McDATA ULTRANETTM EDGE STORAGE ROUTER 3000 Uživatelská příručka stáhnout pdf (Strana 190)

100

101

8-18

McDATA UltraNet Edge 3000 User Guide

Configuring a 1x1 Ethernet Wide Area Network

NOTE: If you do not know what the default gateway (the router IP address

attached to the UltraNet Edge 3000) is at this point, you can add the static

route at a later time. To add static routes at a later time, see

Appendix E,

Modifying Static Routes.

15. Check Set, enter the IP Address of the router directly attached to

Node20 to set the static route.

NOTE: If you are using the Configuration IP Address Worksheet, enter the

following information:

For Node20, enter the gateway address labeled for the circuit on a 1x1 or

2x1 configuration or the 1st circuit of a 1x2 or 2x2.

For the 2nd circuit of a 1x2 or 2x2 configuration, enter the gateway address

labeled .

16. Click Next>.

The IP Circuit Wizard Configure Circuit dialog box appears.

This dialog box enables you to configure the circuit properties.

1 2 ... 185 186 187 188 189 190 191 192 193 194 195 ... 427 428

Komentáře k této Příručce

Žádné komentáře

McDATA ULTRANETTM EDGE STORAGE ROUTER 3000 Uživatelská příručka Strana 190

Komentáře k této Příručce

Související produkty a manuály pro Sítě McDATA ULTRANETTM EDGE STORAGE ROUTER 3000