McDATA OPENconnectors Command Line Interace Uživatelský manuál stáhnout pdf (Strana 71)

100

101

CLI Commands

2-27

config

config.NPIV.setState

Syntax setState NPIVEnabledState

Purpose This command sets the enabled state of the NPIV feature. The NPIV

feature key must be installed in order to enable this feature.

Parameters This command has one parameter:

Command Example

Root> config NPIV setState enable

config.NPIV.show

Syntax show

Purpose This command displays the current NPIV configuration for all ports.

Parameters This command has no parameters.

Command Example

Root> config NPIV show

Output This command displays the following NPIV configuration data:

Output Example The output from the config.NPIV.show command appears as follows:

NPIV state:Enabled

Port Max Allowed NPIV Logins

---------------------------

110

210

310

6 130

...

NPIVEnabledState This parameter can be set to enable or disable.

Boolean 1 and 0 values may also be substituted.

NPIV state The current enabled/disabled state of the NPIV feature.

Max Allowed NPIV Login Table. A table mapping each port number

on the switch to a corresponding max number of NPIV

logins setting.

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 405 406

Komentáře k této Příručce

Žádné komentáře

McDATA OPENconnectors Command Line Interace Uživatelský manuál Strana 71

Komentáře k této Příručce

Související produkty a manuály pro Sítě McDATA OPENconnectors Command Line Interace