McDATA Eclipse 2640 SAN Servisní příručka Strana 81

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 102
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 80
Maintenance and Troubleshooting
3-17
Figure 3-5 Power Supply Alert Shown in Trap Viewer
Performing a Loopback Test
If you suspect there is a hardware problem with a port, you can insert
the loopback connector, which is supplied with the router, into the
port to determine if the port is operating correctly. If the LED turns
solid when the loopback connector is plugged into the port, then the
port hardware is operating correctly. If the LED does not turn solid,
then review the Administration and Configuration Manual for
additional troubleshooting procedures.
NOTE: The loopback connector works only with Ethernet ports; not FC
ports. In order to test a port, you would need to change the port from FC to
Ethernet, then test the port. If you do this, the router will need to be reset.
Zobrazit stránku 80
1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 101 102

Komentáře k této Příručce

Žádné komentáře